A planer comes into use when the woodworker intends to have flat boards of even thickness. Contemporary machines may have a planning platform that helps achieve accurate thickness more quickly. The woodworker adjusts the platform to set the cutting depth, then feeds the board through the machine. The in-feed roller carries the wood forward as it gets placed under the blades of the cutter drum before being moved out of the machine by the out-feed roller. Some planers have both manual and electronic controls.
Use a polyurathane ( I used a Minwax Semi-Gloss ) to seal and protect the finished coffee table. Apply the 1st coat of polyurethane to the entire table. Once dry, add a second coat to the table top. I only generally do one coat of poly on the base. Once the second coat has dried take a sanding block with 400 grit sandpaper and lightly sand all areas you've poly'ed. Then take a clean damp rag to remove the dust and prepare for your final coat of poly.
Apply glue to the ends of the 1 x 2 End Pieces for the Base and Apron, and then clamp them in place against the inside of the Leg. Position the pieces so that one runs flush with the top edge, and the other sets below the line marked in Step 7. Center both pieces on the leg, and tilt them so that they run parallel to the edge of the Leg. Using a drill/driver and 1¼-inch pocket holes screws, attach the pieces to the Leg. Repeat on the opposite end.
Even if you are using a beautiful (yet unstable) grain pattern on part of your furniture, it’s a good idea to use stable wood on the other parts. For example, look at an old wooden door. The panels usually have more decorative (less stable) wood, but the rails and stiles (parts of the frame) are usually very stable straight grained wood (don’t worry, I’ll clarify “straight grain” below).
Carpenters learn many physically-oriented skills, like joining, framing and refinishing. Carpenters also must be adept at measuring and planning to complete the layout portion of their tasks. Errors in this important pre-step to the building process can negatively impact, or even ruin, a finished product. Additionally, mathematical skills and blueprint reading and sketching are vital skills for carpenters.
Training can also offer you the opportunity to specialize in a particular area of this rewarding field, including building maintenance, home renovations, cabinet making, new construction, furniture making, and more. Some programs may even allow you to gain valuable, real-life experience through a paid externship. You'll also learn the latest safety considerations and industry regulations.
While flipping through the boards, keep an eye open for signs that a number of boards may have come from the same tree. Looking at the ends and the growth rings will tell you where in the log the board was sawn. In some cases, knots may go through more than one board, and often the outer boards have a live edge. By comparing these features, the colouring, grain and other distinguishing marks, it is often possible to identify several boards cut from the same log.
The final building step is to lay each plank in place. These will be cut to 20” long each. Attach each piece using wood glue and brad nails. Just make sure the length the nails isn’t longer than the width of the planks and plywood combined. Once you have finished that, you can paint or stain and add your hardware! Because I was using pre-finished white barn wood from Porter Barn Wood, I painted the table before adding the planks. Check out these planks….
I have used a Workmate successfully for years and I am in the process of building an upgraded replacement for the work surfaces. My replacement bench top will be a little longer, much thicker and it will have and extended apron between the two halves to greatly improve holding wood vertically for dovetailing. With this simple upgrade it turns the little Workmate into a very capable portable woodworking bench.