Just a little nitpick on the tape measure blurb. The hook should not be completely tight. It should move in and out about a 1/16th or the thickness of the hook. This way you get an accurate measurement whether you hook a part to measure or bump up to it. If you want more accurate measurements with a tape measure, “burn” an inch instead of hooking or bumping the part. Just line up what you want to measure with the 1″ mark and subtract that inch from the final measurement.
We really like the distressed look on this coffee table. There are a few ways in which you can achieve that. You can use reclaimed wood or you can create the antiqued finish artificially using special techniques. You can analyze the plans and the instructions shared on instructables to find out more about this strategy. They also show you how to build this stylish pinstripe table.
Using wood glue and 1 1/4" pocket hole screws, attach the frame you just built (19" x 11") to the 4x4 frame posts. You will use the pocket holes you drilled in the 19" boards. The frame will sit on the edge of the grooves, not inside. See plans for details. The frame should sit flush with the tops of your 4x4's. This will make the bottom 4" off the ground.
One name rang out like a bell at multiple forums, from many different woodworkers: Steve Wall Lumber. From what we read (NOT direct experience!) it looks like the only way you can go wrong with Wall Lumber is if they don’t have what you’re looking for. The other frequently-cited lumber sellers are worth looking into for sure, as it’s always good to have multiple sources!

The final building step is to lay each plank in place. These will be cut to 20” long each. Attach each piece using wood glue and brad nails. Just make sure the length the nails isn’t longer than the width of the planks and plywood combined. Once you have finished that, you can paint or stain and add your hardware!  Because I was using pre-finished white barn wood from Porter Barn Wood, I painted the table before adding the planks.  Check out these planks….
×