Framing is another part of carpentry. Framing takes skill and experience it’s not a part of carpentry that anyone can just jump into. The skills that are required in framing is plumbing up a wall, make sure studs are 16 on center or whatever the specs calls for. Developing a good eye for straightness in carpentry work. Last but not least making sure everything is level.

Your moisture meter should have settings on it that will account for different species of wood. For instance, oak is a hardwood, but ebony is an even harder density wood. If you are planning an inlay job using both types of wood, you will need to know the moisture content levels of each of the two species so that your inlay glue joints will stay intact. These different wood species have different specific gravities, which must be used or programmed into the moisture meter.


Advanced residential carpenter classes focus on teaching students techniques in planning, measuring, installing fixtures and reading blueprints. Students learn about distance measurement and leveling and also review the equipment and tools used in site layout. Other advanced topics covered are exterior wall components and systems, insulation and applied building codes. Students in advanced carpentry classes also review how to read the symbols and abbreviations used on residential blueprints and practice job estimating, sustainable building practices and energy efficiency techniques.
Rip your 1x4's so they are 3" wide. This should make them nice and square, so they fit together without any gaps or rounded edges. Drill pocket holes in both ends of each board. Drill several pocket holes (3 or 4) on the edges of each board. Spread wood glue on the edges of each board, and sandwich them together, using bar clamps to keep them tight. Using 1 1/4" pocket hole screws, attach the 1x4's together. (see photo on next step)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
×